|
|
|
|
|
|
|
|
|
|
Handy-Handle as recieved-packaged |
|
|
|
|
|
|
|
|
|
|
Step #1 |
|
The two vertical holes are lined up and the two plastic parts are placed into the holes through both pieces. |
|
|
|
|
|
|
|
|
|
|
|
Step #2 |
|
Start the plastic screws into the plastic parts that are already placed in unit (Step #1) |
|
|
|
|
|
|
|
|
|
|
Step #3a |
|
Using a screwdriver and a penny (supplied)--hold one side with the penny and tighten the other side with a screwdriver. |
|
|
|
|
|
|
|
|
|
|
|
|
Step #4a |
|
Wrap the unit into a circle. (make sure the split-flutes are to the inside) Place the final plastic part through the horizontal hole. (same as Step #1)
Repeat Step #3 with the last plastic screw. |
|
|
|
|
|
|
|
|
|
|
|
Step #4b |
|
Note: These holes can be adjusted to fit a smaller or larger diameter bag opening. |
|
|
|
|
|
|
|
|
|
|
Step #5a |
|
The finished unit. Again, make sure the split-flutes are to the inside of the unit and the flaps fold in. |
|
|
|
|
|
|
|
|
|
|
|
|
Step #6a |
|
Attaching the bag: Place the unit inside (at the top) of bag and start at any flap. Using your finger tips push a portion of the bag into each flap and press the flap back into place locking the bag. Do this around all the flaps. (Each flap will make a poping or locking sound when it locks into place.)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Step #7 |
|
Now the attached Handy-Handle is ready to go to work. There are two hand holds. When carrying or holding make sure to hold the unit through the bag into the hand hold (as shown). |
|
|
|
|
|
|
